LED: Cree XM-L2 Neutral White (Nominal CCT
User Selectable Levels: 3 main levels (High, Medium and Low).
Each main level can be programmed to one of its two sub-levels. The second
sub-level of the each main levels can be further programmed to different
Light Output (runtimes)
High: H1 500 Lm (3min, then
304lm, total 0.8 hr) or H2 304 Lm (0.9 hr) / 187 Lm (1.8 hrs) / 107 Lm (3.5
Medium: M1 45 Lm (8.5 hrs) or M2 19 Lm (16.5 hrs) / 7.5 Lm (42 hrs)
Low: L1 3.0 Lm (4 days) or L2 1.0 Lm (16 days) / 0.28 Lm (50 days) / 0.1 Lm
Beacon Strobe Mode: 4Hz Strobe at H1 / 19Hz Strobe at H1
Light output are ANSI out the front (OTF) values.
(and parasitic drain estimated) using Panasonic Eneloop Pro AA batteries.
Remaining battery power, about 10-20%, after step-down are not counted
towards the runtimes.
Operating Voltage Range: 0.7V - 2.0V
One AA size NiMH, lithium or alkaline battery.
Panasonic Eneloop or Eneloop
Pro is highly recommended.
Batteries are not included in the
Parasitic Drain: Negligible (much less than the self discharging of
Beam Type : 80 degree spill
10 degree hot
Dimensions : Head Diameter: 1.0 inch (25.4 mm)
Length: 3.2 inch
Weight : 2.0 oz (58 gram)
indicator (LED flashes 1-4 times, 4 short clicks to start)
stepping down from High to Medium, and from Medium to Low when battery capacity
Durable electronic soft-touch switch
Smart user interface
provides fast and easy access to all brightness levels and
Precision machined unibody casing from premium grade
aluminum bar stocks
Proprietary heat sinking design bonds the LED board
directly to the unibody aluminum casing
Durable natural hard anodized
finish (Type III Class I)
Sealed and potted LED driver circuitry
Battery reverse polarity protection
Tempered optical grade glass
Preinstalled bezel down pocket clip
Battery power can be disconnected by slightly unscrewing the
tailcap to prevent unwanted activations or parasitic drain
IPX7 (2 meters, 30 minutes)